Installation and commissioning
4.4 Battery of the TIM 4R-IE DNP3
TIM DNP3
76 System Manual, 12/2015, C79000-G8976-C253-04
To replace the battery, follow the steps below:
1. Open the battery compartment with a screwdriver as shown in the figure.
2. Remove the old battery.
3. Insert a new battery.
4. Close the battery compartment.
Note
Environmental protection
The used battery contains lithium. The internal components of the battery must not be
allowed to pollute the environment.
Do not dispose of the battery in the domestic refuse.
Make sure that you observe the waste disposal regulations in your country.
Please ask your regional contact concerning the procedure for exchanging old batteries. You
will find additional information in the Internet at: Partner
http://www.automation.siemens.com/partner
Procedure for returning devices with batteries
Remove the battery before returning the device
Remove the battery before returning the device. Batteries must not be returned.
To Next Page
Loading...
Need help?
General
