14
14.2 Installation and Connection
188 Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012
14.2 Installation and Connection
Notes
• The prescribed sequence of operations must be considered and observed when
commissioning the SIMEAS R-PMU.
• Adjustment of the individual data acquisition units at the site is not necessary for the
SIMEAS R-PMU because the device has already been adjusted in the factory.
• For initial delivery, the SIMEAS R-PMU is equipped with the ordered components.
Depending on how communication with a PC or DAKON is planned, the corresponding
interface must be parameterized and put into service.
• If components are installed subsequently in the SIMEAS R-PMU, the respective installation
instructions can be found in Chapter 14.3. After the components have been connected, the
parameters are set for the system.
• To ensure proper functioning, all parameterizations steps described in Chapter 12 must be
carried out.
• The basic parameters are set by default before the SIMEAS R-PMU is delivered. The
following chapters describe the procedure for commissioning the SIMEAS R-PMU.
CAUTION
Caution about wrong transport, storage, installation and mounting of the device.
Nonobservance of the safety instructions means that moderately severe or slight injuries
can occur.
• The trouble-free and safe use of this device depends on proper transport, storage,
installation and mounting of the device taking into account the warnings and instructions in
this manual.
• In particular, the general mounting and safety regulations (e. g. IEC, DIN, VDE, EN or other
national and international standards) for work with power current equipment must be
observed.
To Next Page
Loading...
Need help?
General
