14
14.2 Installation and Connection
196 Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012
14.2.5 Connecting the Cables (Data Transmission)
The standard interfaces for data transmission of the SIMEAS R-PMU are listed below.
14.2.5.1 Connecting the PC, PDC or Notebook via LAN
A RJ45 LAN connector is used for connection. The connection supports
10BaseT/100BaseT and is located at the rear panel.
14.2.5.2 Connecting the PC or Notebook to COM S
A 9-pin D-SUB connection COM S (service interface) is used for connection at the front of the
device.
14.2.5.3 Connecting the PC, PDC or External Modem to COM 1
A 9-pin D-SUB connection COM 1 (data interface) is used for connection at the rear panel.
14.2.5.4 Connecting the Printer to the PRINTER Port
A 25-pin D-SUB connection PRINTER is used for connection at the rear panel.
To Next Page
Loading...
