Siemens SIMOTICS T-1FW6 - Rotor as Individual Component; Ordering Notes

Description of the motor
2.5 Selection and ordering data
1FW6 Built-in torque motors
Configuration Manual, 07/2017, 6SN1197-0AE00-0BP9
43
2.5.1.3
Rotor as individual component
Note
IATA regulations must be complied with when transporting rotors by air.
2.5.1.4
Ordering notes
You can order a complete built-in torque motor (stator, rotor with transport locks) using a
single order designation (article number). Spare parts and accessories can be ordered by
specifying separate order designations (see "Ordering examples (Page 44))".
Note
The cables are permanently attached. You cannot subsequently change the cables.
When selecting a motor, also observe the information in Chapter "
Data for the power cable
at the stator
(Page 506)".
The cooling
connection adapter is not included in the standard built-in torque motor. For the
separate order designation, see Chapter "
Options (Page 91)".
If, for design reasons, only individual components can be installed (stator and rotor
separately), the stator and rotor can be separately ordered and shipped.