Appendix
A.3 Environmental compatibility
1FW6 Built-in torque motors
552 Configuration Manual, 07/2017, 6SN1197-0AE00-0BP9
Environmental compatibility
A.3.1
Environmental compatibility during production
● The packaging material is made primarily from cardboard.
● Energy consumption during production was optimized.
● Production has low emission levels.
The product must be disposed of in the normal recycling process in compliance with national
and local regulations.
Injury or material damage if not correctly disposed of
If you do not correctly dispose of direct drives or their components (especially components
with permanent magnets), then this can result in death, severe injury and/or material
damage.
• Ensure that direct drives and their associated components are correctly disposed of.
Main constituents of a proper disposal procedure
● Complete demagnetization of the components that contain permanent magnets
● Components that are to be recycled should be separated into:
– Electronics scrap (e.g. encoder electronics, Sensor Modules)
– Electrical scrap (e.g. motor windings, cables)
– Scrap iron (e.g. laminated cores)
– Aluminum
– Insulating materials
● No mixing with solvents, cold cleaning agents, or residue of paint, for example
To Next Page
Loading...
Need help?
General