Siemens SIMOTICS T-1FW6 - PIN Assignments for Plug Connectors

Electrical connection
8.3 System integration
1FW6 Built-in torque motors
510 Configuration Manual, 07/2017, 6SN1197-0AE00-0BP9
Table 8- 5 Specifications for the signal cable on the stator
Motor type
Max. diameter
"d2" in mm
1
)
No. of cores (signal cores) x
crosssection + no. of cores
(PE) x cross-section in mm
2
Min. bending
radius "R2"
in mm
1
)
Height of
sleeve "C2"
in mm
Connector
size
2
)
1FW6xxx-xxxxx-xxxx
11
6 x 0.5 + 1 x 1.0
50
18
M17
1
) Signal cable fixed;
2
) Applies to motors with connector
8.3.7
PIN assignments for plug connectors
The pin configurations of the plug connectors are subsequently shown. The view is from the
plug-in side.
Figure 8-35 Pin configuration, Size 1.5 power connector
Figure 8-36 Pin configuration, Size 1.0 power connector