Siemens SIMOTICS T-1FW6 - Technical Features and Ambient Conditions; Directives and Standards

Description of the motor
2.3 Technical features and ambient conditions
1FW6 Built-in torque motors
28 Configuration Manual, 07/2017, 6SN1197-0AE00-0BP9
2.3
Technical features and ambient conditions
2.3.1
Directives and standards
Standards that are complied with
SIMOTICS S, SIMOTICS M, SIMOTICS L, SIMOTICS T, SIMOTICS A motors –
subsequently called the "SIMOTICS motor series " – comply with the following standards:
● EN 60034-1 – Rotating electrical machines – Dimensioning and operating behavior
● EN 60204-1 – Safety of machinery – Electrical equipment of machines; general
requirements
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
IEC / EN 60034:
Feature
Standard
Degree of protection
IEC / EN 60034-5
Cooling
1)
IEC / EN 60034-6
Type of construction
IEC / EN 60034-7
Connection designations IEC / EN 60034-8
Noise levels
1)
IEC / EN 60034-9
Temperature monitoring
IEC / EN 60034-11
Vibration severity levels
1)
IEC / EN 60034-14
1)
Standard component, e.g. cannot be applied to built-in motors
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the area of validity covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.