Siemens SINAMICS GM150

PROFIBUS address switches ③
The PROFIBUS address switch is located under the cover.
ི
Figure 7-6 PROFIBUS address switch cover
7.2.3 Connecting PROFIBUS cables
The figure below shows suitable PROFIBUS connectors with/without a programming device/
PC connector.
352),%86FRQQHFWRUV
ZLWKRXW3*3&FRQQHFWLRQ
(6%$;$
352),%86FRQQHFWRUV
ZLWKSURJUDPPLQJGHYLFH3&
FRQQHFWLRQ
(6%%;$
Figure 7-7 PROFIBUS connectors
1. Connect the cables to the PROFIBUS connector. The bus terminating resistors are located
in this connector.
2. Connect the cable shield over a wide area on both sides.
Start-up
7.2 Description and configuration of the PROFIBUS interface
SINAMICS GM150 6SL3815-2LN41-4AA2
122 Operating Instructions 04/2017