Siemens SINAMICS GM150

8.2.3.3 Fault/alarm memory
Menu structure of the fault memory/alarm memory menu
0DLQPHQX
)DXOW
DODUPPHPRU\
Figure 8-8 Menu structure for fault memory/alarm memory
Alarm overview
If a fault occurs, the drive displays the associated faults and/or alarms on the operator panel
in the "Alarm overview".
Every fault and alarm is entered in the fault/alarm buffer along with time the fault occurred.
The time stamp refers to the relative system time in milliseconds (r0969).
The diagram below shows that currently at least one active fault/alarm is present for the
"VECTOR" drive object. The two other drive objects are fault-free.
ႣႭ
&8B*
9(&725
70




)DXOW$ODUP
'LDJ7RROV
$ODUPRYHUYLHZ
1. Press the <Diag.> function key to display the "Display diagnostics" menu. In this menu the
current and old faults and alarms are displayed.
ႣႭ
&XUUHQWDODUPV
2OGDODUPV
2OGIDXOWV
2OGIDXOWV
2.%DFN
^9(&725`'LVSOD\GLDJQRVWLFV
You can find further information on alarms and faults in the "Operation screens" section.
Operation
8.2 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3815-2LN41-4AA2
146 Operating Instructions 04/2017