Siemens SINAMICS GM150

Resetting the AOP settings
In this menu, you reset the following settings to their default setting:
● Language
● Display settings
● Operation screen
● Control settings
Ⴍ

2.
$23(LQVWHOOXQJHQU¾FNVHW]HQ
'LVSOD\HLQVWHOOXQJHQ
6WHXHUXQJVHLQVWHOOXQJHQ
%HWULHEVPDVNHGHILQLHUHQ
'DWXP8KU]HLWHLQVWHOOHQ
$23(LQVWHOOXQJHQ]XU¾FNVHW]HQ
5HVHW$23VHWWLQJV
<HV
1R
1. Press the <▼> function key to select the "Yes" or "No" setting.
– "Yes:
All settings that are different from the factory settings are reset immediately. The setting
may cause the drive to switch to an unwanted operational states.
– "No":
The values are not reset
2. Confirm the setting with <OK>.
The settings become active immediately.
8.2.3.7 Commissioning / Service - AOP diagnostics
Commissioning / Service / AOP diagnostics menu structure
&RPPLVVLRQLQJ
VHUYLFH
$23
GLDJQRVWLFV
0DLQPHQX
6RIWZDUHGDWDEDVHYHUVLRQ
%DWWHU\VWDWXV
.H\ERDUGWHVW
/('WHVW
&RPPXQLFDWLRQ
)RUPDWIODVK)6
&OHDUSHUVLVWHQWGDWDEDVH



Figure 8-13 Commissioning / Service / AOP diagnostics menu structure
1. Press the <<MENU>> key.
2. Press the <▼> function key to select the "Commissioning/Service" row. Press the <OK>
function key to confirm the selection.
Operation
8.2 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017 157