Siemens SINAMICS GM150

Motor identification
This function has not yet been implemented and will be made available at a later point in time.
Resetting the fan runtime
In this menu, you can reset the fan counter. The fan counter must be reset after a fan
replacement.
1. Press the <▼> function key to select the "Reset runtime" row.
2. Confirm the selection with <OK>. The reset of the fan runtime also clears alarm A30042.
+HOS
%DFN
2.
9(&725BIDQRSHUDWLQJWLPH
IDQRSHUDWLQJWLPH
+RXUV

5HVHWIDQRSHUDWLQJWLPH
8.2.3.6 Commissioning / Service - AOP settings
Commissioning /Service / AOP settings menu structure
&RQWUROVHWWLQJV
'HILQHRSHUDWLRQVFUHHQ
6HWGDWHWLPH
5HVHW$23VHWWLQJV
'LVSOD\VHWWLQJV
$GYDQFHGVHWWLQJV
,&RPPLVVLRQLQJ
VHUYLFH
$23
VHWWLQJV
0DLQPHQX

Figure 8-12 Commissioning /Service / AOP settings menu structure
Calling up AOP settings
1. Press the <<MENU>> key.
2. Press the <▼> function key to select the "Commissioning/Service" row. Press the <OK>
function key to confirm the selection.
3. Press the <▼> function key to select the "AOP settings" row. Press the <OK> function key
to confirm the selection.
4. Press the ▲ or ▼ function key to select the desired setting. Press the <OK> function key to
confirm the selection.
Operation
8.2 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017 153