Siemens SINAMICS GM150 - Page 154

* The "Extended settings" menu appears only when the "special access" access level is
selected.
Control settings
In this menu, set the functions that the AOP control keys should perform. For example, you
can specify whether the <OFF> key is associated with the OFF1, OFF2 or OFF3 function.
More detailed information is available in Chapter "Control settings".
Display settings
Make the following AOP settings in this menu:
● Illumination (on, off after 2 minutes, off)
● Intensity of illumination
● Contrast
ႱႧ
Ⴍ
'LVSOD\VHWWLQJV
/LJKWLQJLQWHQVLW\
&RQWUDVW
/LJKWLQJ
%DFN
ႱႧ&KDQJH


ႱႧ
21
ႱႧ

1. Select the desired setting using the <▼> function key.
2. Change the setting using the <Change> function key.
3. Confirm the setting using the <Back> function key.
Defining the operation screen
In this menu, you can define which parameters the operation screen should display.
A DriveObject (DO) selection is offered on each display. The corresponding parameter list is
offered for each DO. You can select and assign all parameters (r and p). In addition, a selection
of plausible displayable parameters is displayed for each DO.
More detailed information is available in Chapter "Defining operating screens".
Operation
8.2 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3815-2LN41-4AA2
154 Operating Instructions 04/2017