Siemens SINAMICS GM150

Displaying alarms
Alarms are displayed by the yellow "ALARM" LED. Additionally, an appropriate note relating
to the cause is displayed on the operator panel. Up to eight alarms occurring at the same time
are displayed.
+
9(&725)DXOWV
+HOS
%DFN
&OHDU
(UGVFKOXVVZDUQXQJDFWLY
Figure 8-9 Alarm screen
8.2.3.4 Commissioning / service device commissioning
Commissioning / service / device commissioning menu structure

&RPPLVVLRQLQJ
VHUYLFH
'HYLFH
FRPPLVVLRQLQJ
0DLQPHQX

5HDG\
'HYLFHFRQILJXUDWLRQ
'HILQLWLRQRIGULYHW\SH
'ULYHEDVHFRQILJXUDWLRQ
'DWDVHWEDVHFRQILJXUDWLRQ
3DUDPHWHUUHVHW



Figure 8-10 Commissioning / service / device commissioning menu structure
1. Press the <<MENU>> key.
2. Press the <▼> function key to select the "Commissioning/Service" row. Press the <OK>
function key to confirm the selection.
3. Press the <▼> function key to select the "Device commissioning" row. Press the <OK>
function key to confirm the selection.
– The menus marked with "*" appear only when the "special access" access level was
selected
Operation
8.2 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3815-2LN41-4AA2
148 Operating Instructions 04/2017