5.2 Tools required
Installation of the connections requires the following tools:
● Wrench or socket wrench, width across the flats 10, 13, 16/17, 18/19
● Allen key, size 8
● Torque wrench up to 50 Nm
● Screwdriver, size 2
● Torx T20 and T30 screwdrivers
5.3 Removing transport rails
Support rails for crane transportation are attached to the bottom of the cabinet.
To remove the rails, remove the fixing screws ① with an M12 spanner.
Figure 5-1 Removing the support rails
5.4 Screwing the transport units together
NOTICE
Stress
Stress that occurs during transport may exert mechanical pressure on the components.
Material damage can result.
● Line the cabinets up precisely with each other in order to avoid shearing forces when the
base units are screwed together.
● Install the drive only on a level and horizontal surface.
Installation
5.2 Tools required
SINAMICS GM150 6SL3815-2LN41-4AA2
88 Operating Instructions 04/2017
To Next Page
Loading...
