Siemens SINAMICS GM150 - Page 144

Calling up the parameterization menu
1. Press the "MENU" key.
2. Press the <▼> function key to select the "Parameterization" row. Press the <OK> function
key to confirm the selection.
3. Press the <▲> or <▼> function key to select the desired function. Press the <OK> function
key to confirm the selection.
Individual DO
The "Individual DO" function opens the parameter lists for the individual DriveObjects (DO).
1. Press the <▲> or <▼> function key to select the desired DO. Confirm the selection with
<OK>.
2. Press the <▲> or <▼> function key to select the desired parameter. Alternatively, you can
select the parameter by entering the parameter number on the keypad. Parameters with
identical functions may exist with the same parameter number in more than one drive object
(e.g. p0005).
3. Press the <Change> function key to open the change window of the parameter. You can
change the parameter by assigning values or by making a selection from a list.
4. Press the <Help> function key to fetch information about the selected parameter.
All DOs
The "All DOs" function displays a list of the parameters of all the DriveObjects (DO) sorted
numerically. In this list, the same parameter number can appear several times. At the top left,
you see the number of the DO to which the parameter belongs in brackets.
1. Press the <▲> or <▼> function key to select the desired parameter. Alternatively, you can
select the parameter by entering the parameter number on the keypad. Parameters with
identical functions may exist with the same parameter number in more than one drive object
(e.g. p0005).
2. Press the <Change> function key to open the change window of the parameter. You can
change the parameter by assigning values or by making a selection from a list.
3. Press the <Help> function key to fetch information about the selected parameter.
Operation
8.2 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3815-2LN41-4AA2
144 Operating Instructions 04/2017