Siemens SINAMICS GM150 - Page 188

r0046 Missing enable signals
Display of the missing enable signals that are preventing the drive control from being commissioned
Bit Signal name 0-signal 1-signal
18 OFF3 internal enable missing No Yes
26 Drive inactive or not operational No Yes
r0050 Active command data set (CDS)
Display of the active command data set (Command Data Set, CDS)
Bit Signal name 0-signal 1-signal
00 CDS effective, bit 0 No Yes
01 CDS effective, bit 1 No Yes
02 CDS effective, bit 2 No Yes
03 CDS effective, bit 3 No Yes
Further notes can be found in the parameter description of the p0810, p0811, p0812, p0813 and r0836 parameters in the
List Manual.
The command data set selected via binector inputs p0810, p0811, p0812 and p0813 is displayed via r0836.
Diagnostic parameters for digital inputs/outputs
r0721 CU digital inputs terminal actual value
Display of the actual value on the digital inputs
Bit Signal name 0-signal 1-signal
00 DI 0 (X122.1) Low High
01 DI 1 (X122.2) Low High
02 DI 2 (X122.3) Low High
03 DI 3 (X122.4) Low High
04 DI 4 (X132.1) Low High
05 DI 5 (X132.2) Low High
06 DI 6 (X132.3) Low High
07 DI 7 (X132.4) Low High
08 DI/DO 8 (X122.7) Low High
09 DI/DO 9 (X122.8) Low High
10 DI/DO 10 (X122.10) Low High
11 DI/DO 11 (X122.11) Low High
12 DI/DO 12 (X132.7) Low High
13 DI/DO 13 (X132.8) Low High
14 DI/DO 14 (X132.10) Low High
15 DI/DO 15 (X132.11) Low High
If a DI/DO is parameterized as output (p0728.x = 1), then r0721.x = 0 is displayed.
DI: Digital input
DI/DO: Bidirectional digital input/output
Operation
8.5 Fault and system messages
SINAMICS GM150 6SL3815-2LN41-4AA2
188 Operating Instructions 04/2017