Siemens SINAMICS GM150 - Page 98

3RV
3RV
3RV
3RV


3RV
3RV
3RV
3RV
3RV

3RV

① Expanding rivets
② M8 screw, washer, M8 nut
③ Torx screws, size T30
④ Cable ties
Pos. 10 Makrolon plate, connecting part left
Pos. 20 Makrolon plate, connecting part right
Pos. 30 Makrolon plate, rear right
Pos. 40 Makrolon plate, pipe, on the top right
Pos. 50 Makrolon plate, pipe, on the bottom right
Pos. 60 Makrolon plate, center front
Figure 5-9 Dust protection cover, rectifier
1. Pull off the expanding rivets ① using flat-nose pliers.
2. Loosen the Torx screws ③.
3. Pinch off what remains of the cable ties ④ with the side cutter and remove them.
4. Loosen the screws ② with the wrench and remove them.
5. Remove the Makrolon plates one after the other in the following order:
"Pos. 30"
"Pos. 60"
"Pos. 50",
"Pos. 40"
"Pos. 20"
"Pos. 10"
Installation
5.10 Removing the dust protection cover
SINAMICS GM150 6SL3815-2LN41-4AA2
98 Operating Instructions 04/2017