Par. No. Name Range Default Unit
r0052 Actual status word 1 -- -- --
Displays first active status word of inverter (bit format) and can be used to diagnose inverter status.
Bit fields:
Bit00 Inverter ready 0 NO 1 YES
Bit01 Inverter ready to run 0 NO 1 YES
Bit02 Inverter running 0 NO 1 YES
Bit03 Inverter fault active 0 NO 1 YES
Bit04 OFF2 active 0 YES 1 NO
Bit05 OFF3 active 0 YES 1 NO
Bit06 ON inhibit active 0 NO 1 YES
Bit07 Inverter warning active 0 NO 1 YES
Bit08 Deviation setpoint / actual value 0 YES 1 NO
Bit09 PZD control 0 NO 1 YES
Bit10 Maximum frequency reached 0 NO 1 YES
Bit11 Warning: Motor current limit 0 YES 1 NO
Bit12 Motor holding brake active 0 NO 1 YES
Bit13 Motor overload 0 YES 1 NO
Bit14 Motor runs right 0 NO 1 YES
Bit15 Inverter overload 0 YES 1 NO
Note:
For the explanation of the 7-segment display of the bit-parameters (binary parameters), see topic "Operator
panel overview (Page 58)"
r0206 Rated inverter power -- -- kW
Displays nominal rated motor power from inverter.
r0207[2] Rated inverter current -- -- A
Displays maximum continuous output current of inverter.
r0207[0] : Rated inverter current
r0207[1] : Rated motor current of a 4-pole 1LA7 AC motor.
Note:
Under this index 1, you can only view the rated motor current of a 4-pole 1LA7 AC motor. To
view the actual motor current, go to P0305.
r0208 Rated inverter voltage -- -- V
Displays nominal AC supply voltage of inverter.
Value:
r0208 = 400 ( 400 V, tolerance: -15% - +15%)
r0209 Maximum inverter current -- -- A
Displays maximum output current of inverter.
Dependency:
Parameter r0209 depends on the derating which is affected by pulse frequency P1800, ambient temperature
and altitude. The data of derating is given in the Operating Instructions.
Parameter list
SINAMICS V10
Operating Instructions, 08/2011, A5E03453178 (this is not an order number) 81
To Next Page
Loading...
