PROFIBUS_TRACE_START
13113, 80
PROFIBUS_TRACE_START_EVENT
13114, 80
PROFIBUS_TRACE_TYPE
13111,
79
PROG_EVENT_IGN_INHIBIT
20107, 117
PROG_EVENT_IGN_PROG_STATE
20192, 135
PROG_EVENT_IGN_REFP_LOCK
20105, 116
PROG_EVENT_IGN_SINGLEBLOCK
20106, 116
PROG_EVENT_IGN_STOP
20193, 136
PROG_EVENT_MASK
20108, 118
PROG_EVENT_MASK_PROPERTIES
20109, 118
PROG_EVENT_PATH
11622, 74
PROG_FUNCTION_MASK
10280, 37
PROG_NET_TIMER_MODE
27850, 193
PROG_SD_POWERON_INIT_TAB
10709, 43
PROG_SD_RESET_SAVE_TAB
10710, 44
PROG_TEST_MASK
10707, 43
Program control from the HMI (retentive area), 458
Program selection via lists, 459
PROTOC_IPOCYCLE_CONTROL
11297, 65
PROTOC_PREPTIME_CONTROL
11298, 65
R
RATED_OUTVAL
32250, 235
RATED_VELO
32260, 236
Reading / writing NC data: Job, 454
Reading / writing NC data: Result, 455
Reading and writing PLC variables, 483
REFP_CAM_DIR_IS_MINUS
34010, 256
REFP_CAM_IS_ACTIVE
34000, 256
REFP_CAM_MARKER_DIST
34093, 261
REFP_CAM_SHIFT
34092, 261
REFP_CYCLE_NR
34110, 262
REFP_MAX_CAM_DIST
34030, 257
REFP_MAX_MARKER_DIST
34060, 259
REFP_MOVE_DIST
34080, 260
REFP_MOVE_DIST_CORR
34090, 260
REFP_NC_START_LOCK
20700, 158
REFP_PERMITTED_IN_FOLLOWUP
34104, 262
REFP_SEARCH_MARKER_REVERSE
34050, 258
REFP_SET_POS
34100, 261
REFP_STOP_AT_ABS_MARKER
34330, 266
REFP_VELO_POS
34070, 259
REFP_VELO_SEARCH_CAM
34020, 257
REFP_VELO_SEARCH_MARKER
34040, 257
REPOS_MODE_MASK
11470, 72
RESET_MODE_MASK
20110, 119
Retentative data, 456
ROT_IS_MODULO
30310, 214
S
S functions from NCK channel, 465
S_VALUES_ACTIVE_AFTER_RESET
22400, 170
SCALING_SYSTEM_IS_METRIC
10240, 36
SCREEN_SAVER_WAIT_TIME
9000, 31
SD_MAX_PATH_ACCEL
42500, 321
SD_MAX_PATH_JERK
42510, 322
Index
Parameter Manual
512 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
To Next Page
Loading...
Need help?
General
