Siemens SINUMERIK 808D User Manual

Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
257
28.
Press this softkey to return to the window for CYCLE72 and enter the desired parameters
as follows:
29.
Press this softkey to confirm your input and open the cycle programming window.
Enter the following program blocks:
S4000 M3
30.
Proceed through the steps described earlier to copy the entire program block for CYCLE72
and paste it in the line after the above blocks.
31.
Press this softkey to open the window for CYCLE72 again. Change the values of "MID",
"FAL", "FALD" and "VARI" to "5", "0", "0" and "112" respectively.
32.
Press this softkey to confirm your input and open
the cycle programming window.
Enter the following program blocks:
G0 Z100
S3500 M3
33.
Press this key to enter a new line.
34.
Open the window for POCKET3 through the following softkey operations:
→
35.
Enter the desired parameters as follows:
36.
Press t
his softkey to confirm your input and open the cycle programming window.
Enter the following program blocks:
S4000 M3

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English