Siemens SINUMERIK 810D

Starting Up HMI Embedded (IM2) 08/2005
4 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM2/4-40 SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
4.2.7 Geometry processor
You have two possibilities of specifying the text output at the end of a contour and
to set the representation of the contour elements:
1. Via the HMI user interface
2. Via the display machine data MD 9460: PROGRAM_SETTINGS
Settings from the HMI user interface
Press the "Contour settings" vertical softkey.
The window pane: "Free contour programming settings" will be opened:
- Enter after "Text output at the end of the contour programming" the text that is
to appear after each contour, e.g. "Contour end"
You can select/deselect other settings:
- Technology specifications: "Rotate"
- Show graphically softkey for geometry elements
Settings in the display machine data
The following section describes the settings in the display machine data as used in
HMI Embedded:
Bit 0
= 1 Technology rotating (contour support)
Bit 3
= 0 The softkeys for selecting the contour elements are assigned
text.
= 1 The softkeys for selecting the contour elements are assigned
icons.
4.2.8 File manager
You can use the file manager to select a connection as standard directory for all
created drives.
You can specify the selection of this standard directory using a display machine
data or via the HMI user interface:
1. Via the display machine data MD 9005: PRG_DEFAULT_DIR:
You can use the Select key to select all created drive connections (1 to
max. 8).
2. From the HMI user interface:
Click the "Settings" vertical softkey and the "Program overview" vertical
softkey. All created drives will be shown. The Select key is used to select a
connection to be used as standard directory; it is saved with the "OK"
softkey.