08/2005 Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IM4/2-109
2.5.22 SEDITOR.INI
Application
You can modify the displays in the multi-channel sequential programming
(option) by means of settings or by making your own additions in this file.
The sections that contain the designation [ *User* ] enable the cycles of the
machine manufacturer and the user to be identified and displayed. In addition,
other details can be specified.
To configure your own steps, settings can be made in the following sections:
• [SyncMarks_User]
Expansions to incorporate synchronization
marks
• [USER_VARIABLES]
Variables for channels with synchronization
marks
• [Old_or_User_Cycles_USER]
Expansions for user cycles, any variable names
can be entered here.
• [ProgSupport_User]
Expansions to incorporate your own cycles
The merge mechanism is used for the settings so that, unlike in the standard
version of the ini file, only changes and additions have to be stored in the Add-on,
oem, and user directories.
Also refer to: "MMC.INI", [PROGRAM] Section on page 103.
Syntax rules
Note the following information regarding your expansions:
;*************************************************************
;The following rules must be used for the sections:
; - [SyncMarks_Siemens]
; - [SyncMarks_User]
; - [Old_or_User_Cycles_Siemens]
; - [Old_or_User_Cycles_USER]
;
;- You can use either *- or ?-statements.
; Do not mix these placeholders:
;
; L1* -> OK
; L1?? -> OK
; L1?1* -> NOT OK !!!
;
;- ? is replaced with numbers from 0 to 9, so the step editor
; will find the following strings:
;
; L1? -> L10, L19, L15, but NOT L1A
; LB?? -> LB23, LB99, LB00, but NOT LB1A or LBd6
;
;- You can use the ?-statement once per entry:
; L1? -> OK
; L1?? -> OK
; L23??? -> OK
; L2??3? -> NOT OK !!!
;*************************************************************
To Next Page
Loading...
Need help?
General
