Siemens SINUMERIK 810D

Commissioning HMI Advanced (IM4) 08/2005
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM4/2-70 SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
2.4.9 Tool Management (WZV)
Application
The Tool Management HMI Advanced already contains the functionality.
The structure of the NCDDE variables of tool management follows the pattern:
“TMHMICurData_”<MMCName>”_”<DataName>
with TMHMI = Tool Management Human Machine Interface
The following current data (<DataName>0) are present:
General TOA and channel data:
- curTOANo Current TOA number
- curChannelNo Current channel number
Current tool in list views (tool in which the cursor lies) and in tool data images for
individual tools:
- curToolTNo T number
- curToolIdent Tool identifier
- curToolDuplo Tool duplo number
- curToolType Tool type
- curEdgeNo Tool edge number, relative to tool and not to duplo
number!
- curDLNo Tool edge correction location number, relative to edge
- curMagNo Magazine number; “0” if the current tool is not situated
on a place or is intended for it.
- curPlaceNo Magazine place number; “0” if the current tool is not
situated on a place or is intended for it.
Current magazine in magazine list view
- curMagLiMagNo Magazine number,
target magazine, target magazine place during loading, unloading, reloading,
positioning, empty place search:
- targetMagNo Magazine number
- targetPlaceNo Magazine place number
source magazine, source magazine place during loading, unloading, reloading,
positioning, empty place search:
- sourceMagNo Magazine number
- sourcePlaceNo Magazine place number
Current tool in tool cabinet:
- curCabToolIdent Tool identifier
- curCabToolDuplo Tool duplo number
- curCabToolType Tool type