08/2005 Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IM4/2-119
2.6 Simulation Data Synchronization
This function can be used to simulate machining on screen. Data evaluated by the
simulation has to be copied into data management in the Dialog
programming\Simulation data directory (\DP.DIR\SIM.DIR).
When the simulation program is started the following functions can be selected with
the Data matching softkey:
• Match setup data
• Match tools
• Match machine data
• Match cycles
2.6.1 Simulation Data
Files used
When HMI Advanced is started up, the following files are initialized for the
simulation in data management directory \DP.DIR\SIM.DIR.
UMAC.DEF User macros
SMAC.DEF System macros
SMAC_SC.DEF "
MMAC.DEF Machine manufacturer macros
UGUD.DEF Global user data
SGUD.DEF Global system data
MGUD.DEF Global machine manufacturer data
GUD4.DEF NC user data 4
GUD5.DEF NC user data 5
GUD6.DEF NC user data 6
GUD7.DEF NC user data 7
GUD7_SC.DEF "
GUD8.DEF NC user data 8
GUD9.DEF NC user data 9
CH(c)_RPA.INI R parameters (channel-specific)
CH(c)_GUD.INI, NC_GUD.INI User data (channel-specific, global)
CH(c)_SEA.INI, NC_SEA.INI Setting data (channel-specific, global)
AX_SEA.INI Setting data for axes
CH(c)_UFR.INI, NC_UFR.INI
Work offsets (channel-specific, global)
CH(c)_PRO.INI Protection zones (channel-specific)
NC_CEC.INI Sag/angularity
TO_INI.INI Tool data (complete)
INITIAL.INI NCK initialization data
DPCUSCYC.COM Description of the user cycle interfaces
To Next Page
Loading...
Need help?
General
