Commissioning HMI Advanced (IM4) 08/2005
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM4/2-106 SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
2.5.19 PARAM.INI
[ACCESSLEVEL]
READ_SYSVAR=7
EDIT_VIEW=7
;Tool compensation user data
;Tool-specific parameters
[ToolParams]
UserDataParamName1=T_Param_1
UserDataParamName2=T_Param_2
UserDataParamName3=T_Param_3
UserDataParamName4=T_Param_4
UserDataParamName5=T_Param_5
UserDataParamName6=T_Param_6
UserDataParamName7=T_Param_7
UserDataParamName8=T_Param_8
UserDataParamName9=T_Param_9
UserDataParamName10=T_Param_10
;Cutting edge-specific parameters
[ToolEdgeParams]
UserDataParamName1=D_Param_1
UserDataParamName2=D_Param_2
UserDataParamName3=D_Param_3
UserDataParamName4=D_Param_4
UserDataParamName5=D_Param_5
UserDataParamName6=D_Param_6
UserDataParamName7=D_Param_7
UserDataParamName8=D_Param_8
UserDataParamName9=D_Param_9
UserDataParamName10=D_Param_10
The tool compensation (turning) is calculated in Diameter when the selected axis
is equal to the traverse axis and the entry CalDiaVal=1 is set in the [Bezugma]
section in the Param.ini file.
2.5.20 PARAMTM.INI
The full range of parameter settings are presented in the tool management
description.
References: /FBW/ Description of Functions Tool Management
To Next Page
Loading...
Need help?
General
