08/2005 Starting Up HMI Embedded (IM2)
4 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
IM2/4-53
Note
To hide the PRESET, preset actual value memory and scratching softkeys, the
display machine data 9220: MM_USER_CLASS_PRESET can be set.
Preset actual value memory
Preset actual value memory with system frame
G500 active
- The values are written to the system frame
G500 not active
- An error message is output.
Preset actual value memory without system frame
G500 active (adjustable frames reset)
- The values are written to the first basic frame (up to software version 4),
or (as of software version 5)
depending on the entry in display machine data
MD 9245: MA_PRESET_FRAMEIDX = index of basic frame
to the set basic frame
Scratching
Scratching with system frame
G500 active
- The values are written to the system frame.
G500 not active
- The values are written in the currently active frame.
You cannot choose any tool other than the one in the spindle.
If there is no tool in the spindle, you can choose any tool you want.
Scratching without system frame
G500 active (adjustable frames reset)
- The values will written in the set basic frame depending on the entry in the
display machine data
MD 9245: $MM_MA_PRESET_FRAMEIDX = index of base frame
G500 not active
- The values are written in the currently active frame.
G500 not active
- An error message is output.
You can select any tool you want.
References: /FB1/ Description of Functions, K2: Frames...
To Next Page
Loading...
Need help?
General
