Commissioning HMI Advanced (IM4) 08/2005
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM4/2-94 SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
AUTO_V_ISTW=7 ; watch windows of Actual-values,
==>7 Suggestion everyone
; Spindles, G functions, Aux. functions,
; Feedrate, Tools or Axis feedrate in AUTO mode
AUTO_V_ZOOM=7 ; Zoom actual values in AUTO mode
==>7 Suggestion everyone
AUTO_V_NCPR=7 ; Program overview in AUTO mode
==>6 Suggestion operator
AUTO_OP_NCPR=7 ; load + select program in AUTO mode
==>6 Suggestion operator
AUTO_ED_NCPR=7 ; Alter enable status of Prog in AUTO mode
==>5 Suggestion machine setter
AUTO_SYNAKT=7 ; synchronous actions in AUTO mode
==>5 Suggestion machine setter
AUTO_INCHMET=7 ; Switch inch/metric in AUTO mode
==>6 Suggestion operator
[Customer]
MDASingleSTEP=yes
ONLY_MKS_ToolBaseDistToGo=no
NcVersionCheck=true
; Due to performance issues the functionality offered with respect to
; block correction, block view and block search depends on the
; Nc-version currently used.
; However, to get access to the whole functionality, regardless of the
; Nc-Version in use,
; set the flag NcVersionCheck to False.
[BlockSearch]
; Shows (SeruproEnabled=1) or
; hides (SeruproEnabled=0)
; the softkey used to do a block search in mode "programtest".
; The softkey appears in both dialogs
; "Blocksearch Searchposition" and "Blocksearch Searchpointer"
SeruproEnabled=1
; When doing a block search in mode "programtest" you can do
; a multi-channel block search. There are 4 channel-configurations which
; define the NC-channels being affected by the block search:
; SeruproConfig =
; 1: selected/active channel
; 2: selected/active channel and all channels having selected the same
; workpiece as the active channel
; 3: selected/active channel and all channels belonging to the active
; channel’s mode group
; 4: all NC-channels
SeruproConfig=1
To Next Page
Loading...
Need help?
General
