Siemens SINUMERIK 810D Commissioning Manual

08/2005 Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IM4/2-97
; drive- and device type-specific alarm text files
[DriveTextFiles]
ALDEV_80E5=f:\dh\mb.dir\aldvs_
ALDRV_80E5=f:\dh\mb.dir\aldrs_
;ALDEV_808F=f:\dh\mb.dir\aldvu_
;ALDRV_808F=f:\dh\mb.dir\aldru_
ALDEV_x=f:\dh\mb.dir\aldvp_
ALDRV_x=f:\dh\mb.dir\aldrp_
[IndexTextFiles]
ALNX=f:\dh\mb.dir\alnx_
ALSI=f:\dh\mb.dir\alsi_
; default definition of the priorities of the different alarm types
[DEFAULTPRIO]
CANCEL=100
RESET=100
POWERON=100
NCSTART=100
PLC=100
PLCMSG=100
MMC=100
; This section defines different characteristics of the log that
; specifies how particular error messages are to be registered.
[PROTOCOL]
For details on formation of filter expressions for control of message
volume, refer to "Outputting the Alarm Log."
; Criteria for selecting the alarm messages to be recorded. The notation
; is described in SINUMERIK 840D OEM package HMI User's Manual.
Filter=Expression
; Characterizes the numbers of entries in the log file. If the actual
; number exceeds this value, the server starts to overwrite old entries
; (principle: ring buffer)
Records=150
; Mode of alarm log writing
; if a number less than -1 is specified, this number of log files is
; kept in parallel, and one of them is actually used
; if -1 is specified, the log file is not automatically updated
; if 0 is specified, the log file is immediately updated
; if a number greater than 0 is specified, the log file is updated after the
; specified number of seconds elapses with no intermediate alarm state
; changes. The log file is always updated when you send the
; DDE command "AlarmProt" to the MBDDE server
; (principle: ring buffer) ---------------------------------------------------------------
DiskCare=−1 # attention: the mode changed from V4 to V5 !
The multiple file strategy can also be selected by means of the DiskCare entry in
the Ini file.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English