Siemens SINUMERIK 810D

08/2005 Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IM4/2-149
%_N_MMC_EXAMPLE5_MPF
N15 MMC("CYCLES,PICTURE_ON,T_SK.COM,SCREEN8,GUD4.DEF,GRA.BMP,,
M1","S")
N30 MMC("CYCLES,PICTURE_OFF","N")
M30
%_N_MMC_EXAMPLE6_MPF
N10 MMC("CYCLES,PICTURE_ON,T_SK.COM,SCREEN4,GUD4.DEF,,,H1","S")
N20 TEST_2 = 12
N30 MMC("CYCLES,PICTURE_ON,T_SK.COM,SCREEN5,GUD4.DEF,,,I1","S")
N35 MMC("CYCLES,PICTURE_OFF","N")
N40 M30
%_N_MMC_EXAMPLE7_MPF
N15 MMC ("CYCLES,PICTURE_ON,T_SK.COM,SCREEN7,GUD4.DEF,,,J1","S")
N20 TEST_1 = 5
N30 MMC("CYCLES,PICTURE_OFF","N")
M30
%_N_MMC_EXAMPLE8_MPF
N10 QUIT_1 = "START"
N20 MMC("CYCLES, PICTURE_ON,T_SK.COM,SCREEN3,GUD4.DEF,,
QUIT_1,K1","A")
N30 LABEL0:
N40 STOPRE
N50 IF MATCH (QUIT_1,"SK1") >= 0 GOTOF LABEL1
N60 IF MATCH (QUIT_1,"SK2") >= 0 GOTOF LABEL2
N70 GOTOB LABEL0
N80 LABEL2:
N90 MMC("CYCLES, PICTURE_ON,T_SK.COM,SCREEN1,GUD4.DEF,,,N1","N")
N100 G4 F10
N110 LABEL1:
N120 MMC("CYCLES, PICTURE_OFF","N")
N130 M30