Siemens SITOP UPS1100 - Page 112

Engineering and remote access
3.6 Cyclic and acyclic data
SITOP UPS1600 / BAT1600 / UPS1100
112 Equipment Manual, 07.2021, A5E37775406-11-76
Data
Description
Data type
Batt 4: Standby time [1 s]
Standby time
Unsigned32
Batt 4: Buffer time [1 s]
Time in buffer mode
Unsigned32
Batt 4: Total charging current
[1 mAh]
Total charge level (battery-specific data): Total charge within the
service life of the SITOP UPS1600.
Unsigned32
Batt 4: Total culled current [1 mAh]
Total charge level used (battery-specific data): Total discharge over
the service life of the SITOP UPS1600.
Unsigned32
Batt 4: EOCV [0.01 V]
"End-of-charge voltage": Battery voltage when charging changes to
trickle charging. The energy storage device is then charged up to
100 %.
Unsigned16
Batt 4: Charge current [1 mA]
Charge current: Current magnitude used to charge the connected
battery modules during the constant current charging phase.
Unsigned16
Batt 4: Battery capacity [0.1 Ah]
Battery capacity: Total battery capacity of all energy storage devic-
es connected to the SITOP UPS1600
Unsigned16
Batt 4: Stop buffering voltage
[0.01 V]
Battery voltage, which when fallen below, buffer mode is exited
(stop buffering voltage).
Unsigned16
Batt 4: Battery type
Battery type
Unsigned8
Batt 4: Minimal temperature [1 °C]
Lowest specified operating temperature of the SITOP BAT1600 or
SITOP UPS1100 battery module being used
Signed8
Batt 4: Maximal temperature [1 °C]
Highest specified operating temperature of the SITOP BAT1600 or
SITOP UPS1100 battery module being used
Signed8
Fill byte(s)
-
1 x Unsigned8
Batt 4: Order number
Order number (Article number).
VisibleString(20)
Batt 4: Serial number
Serial number
VisibleString(16)
Batt 4: Manufacturing date
Manufacturing date
VisibleString(8)
Batt 4: Version number
Version number
VisibleString(6)
Batt 4: Calculated battery health
Calculated battery health
Unsigned8
Batt 4: Operating state
Operating state
Unsigned8
Batt 4: LED state
LED states
Unsigned8
Fill byte(s)
-
3 x Unsigned8
Batt 4: SWD
SW revision
Unsigned32
Batt 4: Battery MID
Battery Module Ident Number
Unsigned32
Batt 5: Standby time [1 s]
Standby time
Unsigned32
Batt 5: Buffer time [1 s]
Time in buffer mode
Unsigned32
Batt 5: Total charging current
[1 mAh]
Total charge level (battery-specific data): Total charge within the
service life of the SITOP UPS1600.
Unsigned32
Batt 5: Total culled current [1 mAh]
Total charge level used (battery-specific data): Total discharge in
the service life of the SITOP UPS1600
Unsigned32
Batt 5: EOCV [0.01 V]
"End-of-charge voltage": Battery voltage when charging changes to
trickle charging. The energy storage device is then charged up to
100 %.
Unsigned16
Batt 5: Charge current [1 mA]
Charge current: Current magnitude used to charge the connected
battery modules during the constant current charging phase.
Unsigned16
Batt 5: Battery capacity [0.1 Ah]
Battery capacity: Total battery capacity of all energy storage devic-
es connected to the SITOP UPS1600
Unsigned16
Batt 5: Stop buffering voltage
[0.01 V]
Battery voltage, which when fallen below, buffer mode is exited
(stop buffering voltage).
Unsigned16
Batt 5: Battery type
Battery type
Unsigned8
Batt 5: Minimal temperature [1 °C]
Lowest specified operating temperature of the SITOP BAT1600 or
SITOP UPS1100 battery module being used
Signed8