Siemens SITOP UPS1100 - SIMATIC STEP 7 in the TIA Portal; Introduction; Installing the Hardware Support Package (HSP)

Engineering and remote access
3.4 SIMATIC STEP 7 in the TIA Portal
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
63
3.4 SIMATIC STEP 7 in the TIA Portal
3.4.1 Introduction
In SIMATIC STEP 7 in the TIA Portal, the basic unit SITOP UPS1600 and its battery modules
SITOP BAT1600 or SITOP UPS1100 can be integrated in projects, parameterized and
diagnosed.
Note
If you use SIMATIC STEP
7 in the TIA Portal, and the SITOP UPS1600 version to be configured
is not supported, then you must install the appropriate Hardware Support Package (HSP) or
the appropriate generic station description file (GSD) in order to be able to use the SITOP
UPS1600 and the supplementary modules
.
You can find more information at
Installing the Hardware Support Package (HSP) (Page 63
) or
Installing the generic station description file (GSD) (Page 64).
3.4.2 Installing the Hardware Support Package (HSP)
Note
The HSP is available at our SITOP
-homepage (http://www.siemens.com/sitop-ups1600) or
directly at (https://support.industry.siemens.com/cs/ww/de/view/72341852/en?dl=en).
Procedure
To install the Hardware Support Package, proceed as follows:
1. Start STEP 7 in the TIA Portal.
2. In the "Options" menu, click on "Support Packages".
Dialog "Detailed information" opens.
All Support Packages from the directory that you specified as storage location for Support
Packages in the settings are listed in a table.