Engineering and remote access
3.5 SIMATIC STEP 7
SITOP UPS1600 / BAT1600 / UPS1100
92 Equipment Manual, 07.2021, A5E37775406-11-76
3.5.4 Parameter assignment
3.5.4.1 Parameters of the basic device and battery module
The adjustable parameters of the basic unit SITOP UPS1600 and the SITOP BAT1600 battery
modules or SITOP UPS1100 are structured according to subgroups in SIMATIC STEP 7. These
subgroups are shown in the table below.
Parameters to configure the response of the SITOP UPS1600 when buffering
Configuring the interruption when the supply voltage returns
Parameters for determining the possible buffer time
Parameters for using third-party batteries
Parameters for the charging behavior:
• End-of-charge voltage
• Charge current
Time synchronization via the Network-Time-Protocol
A detailed description of the individual parameters of the subgroups is contained in the
associated section under Parameterizing SITOP UPS1600 (Page 92).
3.5.4.2 Parameterizing SITOP UPS1600
The procedure is the same for all parameters. This section describes the general procedure to
reach the configuration dialog. The individual parameters and their possible values are
described in the following subsections.
Each parameter has a start value. A click on "Reset to initial values" resets all parameters of a
subgroup to the associated start value.
Preconditions
• The SITOP UPS1600 has been integrated in the opened project and networked.
Procedure
1. Open the Network view "NetPro" ("Options > Configure network").
The controller and the networked SITOP UPS1600 are displayed.
2. In the Network view click on SITOP UPS1600. The hardware configuration opens.
3. Double click in the hardware configuration on the SITOP UPS1600 entry in the station
window for slot 0.1.
4. In the configuration dialog click on the "Parameters" tab.
To Next Page
Loading...
