Siemens SITOP UPS1100 - Inserting SITOP UPS1600 into a Project

Engineering and remote access
3.5 SIMATIC STEP 7
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
89
The installed devices are imported into the module catalog and can then be integrated in the
project. You can find SITOP UPS1600 in the hardware catalog under
"PROFINET IO\I/O\UPS1600".
3.5.3 Inserting SITOP UPS1600 into a project
To be able to use the SITOP UPS1600, you must assign an IO controller as IO device
(SIMATIC S7 controller).
Preconditions
• The GSD file of the SITOP UPS1600 has been correctly installed.
• SIMATIC STEP 7 has been opened and a project has been created with an IO controller
(SIMATIC S7 control).
Creating a subnet
1. Open the Hardware view "HW Config".
2. Call the shortcut menu of line "PN-IO"
3. Select "Insert PROFINET IO system".
4. In dialog field "Properties - Ethernet interface PN-IO", select the "Parameters" tab.
5. Set the IP address of the PROFINET interface.