Siemens SITOP UPS1100 - Signal Connector

Mounting/removing
5.1 SITOP UPS1600
SITOP UPS1600 / BAT1600 / UPS1100
188 Equipment Manual, 07.2021, A5E37775406-11-76
Removal
To remove, carefully open the slider ⑩ using a screwdriver or by hand (see Figure 5-1
Removal (example 6EP4136-3AB00-2AY0) (Page 188)) and disengage the device at the
bottom edge of the DIN rail. Then you can remove the device from the upper edge of the DIN
rail.
Figure 5-1 Removal (example 6EP4136-3AB00-2AY0)
5.1.1 Signal connector
Mounting
Push connector on socket ④ in the housing.
Removal
To remove the signal connector, press the release lever (4b) (see Figure 5-2
Mounting/removal: Signal connector (Page 188)) and then remove the connector.
Figure 5-2 Mounting/removal: Signal connector