Siemens SITOP UPS1100 - Sitop Ups1100

Description, device design, dimension drawing
2.2 Connections and terminal designation
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
33
2.2.3 SITOP UPS1100
Power terminal ① and signal terminal ② can be used to establish the connection to
SITOP UPS1600 (also see Chapter Installation (Page 211)).
Connections and terminal designations
(see Figure 2-4 SITOP UPS1100 design (example 6EP4133-0GB00-0AY0) (Page 25))
① DC power terminal +, -
One screw terminal each
② Signal terminal 1, 2
One screw terminal each
Figure 2-14 Terminal data for 6EP4131-0GB00-0AY0, 6EP4132-0GB00-0AY0 and 6EP4133-0GB00-
0AY0
*1)
16 mm² for square crimping, otherwise 10 mm²
Figure 2-15 Terminal data for 6EP4133-0JB00-0AY0, 6EP4134-0GB00-0AY0 and 6EP4135-0GB00-
0AY0