Siemens SITOP UPS1100 - Connections and Terminal Designation; Sitop Ups1600; Terminals

Description, device design, dimension drawing
2.2 Connections and terminal designation
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
27
2.2 Connections and terminal designation
2.2.1 SITOP UPS1600
2.2.1.1 Terminals
The input terminals ① can be used to establish the connection to the supply voltage. The
output terminals ② are used to connect to the supplied loads.
The cables used must be suitable for temperatures of at least 90 °C.
UPS1100 battery modules are connected via DC power terminals BAT ③.
(see also Chapter Installation (Page 211))
Connections and terminal designations
(see Figure 2-1 SITOP UPS1600 design (example 6EP4136-3AB00-2AY0) (Page 21))
① DC input IN+, IN-
One screw terminal each
② DC output OUT+, OUT-
One screw terminal each
③ DC power terminals to connect a battery mod-
ule BAT+, BAT-
One screw terminal each
④ Signal connector
Connector with 14 screw terminals
⑤ PROFINET (Ethernet) connection
RJ45 plug-in contact (only for ...-2AY0)
⑥ USB connection
USB-B plug-in contact (only for ...-1AY0)
Figure 2-5 Terminal data SITOP UPS1600 10 A, 20 A