Siemens SITOP UPS1100 - Parameterizing the UPS1600

Engineering and remote access
3.4 SIMATIC STEP 7 in the TIA Portal
SITOP UPS1600 / BAT1600 / UPS1100
70 Equipment Manual, 07.2021, A5E37775406-11-76
3.4.7 Parameterizing the UPS1600
The adjustable parameters of the SITOP UPS1600 can be found in STEP 7 in the TIA Portal in
the inspector window under Properties when the appropriate device was selected.
For parameterization, in the area navigation, the settings under "Device configuration" ("Base
Unit", "Energy storage") and "Web server" are relevant.
Navigation area
Description
Device configu-
ration
Base Unit
Buffering
All parameters, which involve the behavior of SITOP
UPS1600 when buffering
Signaling
Setting of the alarm signaling and the wait time for stable
input voltage.
Charging
Charging the battery
Energy storage
-
Parameters for the battery modules used
Navigation area
Description
Web server
General
Defines whether it is permissible to access SITOP UPS1600 via the web server
(yes / no)
Activate the web server on this module
Activate automatic logoff
Access only via HTTPS
Automatic update
Activate automatic update
Activation interval
Navigation area
Description
OPC UA server
General
OPC UA Server activat-
ed
Here, activate the OPC UA server.
OPC UA server port
Specify which port should be used.
Security Policies
Activation of anony-
mous access
No security
If the option is activated, then unencrypted access via the
OPC UA client is possible. Activating the option is not
recommended.
Basic128 - Sign & En-
crypt
Allow Basic128 security profile for OPC UA communica-
tion.
Basic256 - Sign & En-
crypt
Allow Basic256 security profile for OPC UA communica-
tion.
Basic256Sha256 - Sign
& Encrypt
Allow Basic256Sha256 security profile for OPC UA com-
munication.
Navigation area
Description
NTP client
NTP client activat-
ed
Here, activate the NTP client.
NTP server
Address 1 … 4
Enter up to 4 addresses for an NTP server.