Engineering and remote access
3.9 Web server
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
149
Note
For security reasons, when installing for the first time, the default password should be
changed. Further, it is recommended that passwords are regularly changed.
Procedure for setting up a guest access
1. Select the "Hardware configuration" menu.
2. Select submenu "General > User administration".
3. Enter a password in the editor area under "guest" and select the individual access rights for
guest access.
4. Enter the password again under "Confirm password".
5. Load the data to the device.
Procedure for setting up a user account
1. Select the "Hardware configuration" menu.
2. Select submenu "General > User administration".
3. In the editor area, click on "Add new user" and in this line enter the name for the new user.
4. Select the individual access rights for the new user.
5. Enter a password for the new user - and repeat this to confirm the password.
6. Load the data to the device.
3.9.7.2 Device configuration
You set the parameters for basic units and energy storage devices under menu item "HW
Configuration > Device configuration".
To Next Page
Loading...
