Engineering and remote access
3.7 SITOP Manager
SITOP UPS1600 / BAT1600 / UPS1100
128 Equipment Manual, 07.2021, A5E37775406-11-76
The scope of the services is described below:
1. The SITOP Manager service (MGR) - represented by symbol (
) - is used to browse,
develop, commission and monitor several SITOP objects such as SITOP PSU8600, SITOP
UPS1600, SITOP DC UPS module, SITOP UPS500P, SITOP UPS500S, SITOP Shutdown Service
and/or SITOP Gateway Service. The user interface is implemented using a web interface, and
can either be locally or remotely called.
2. The SITOP Shutdown Service (SDS) - represented by symbol (
) - is responsible for
communication between IPC, on which it is installed, and a buffer device (i.e. SITOP
PSU8600 SITOP, UPS1600, SITOP DC UPS module, SITOP UPS500P and SITOP UPS500S). This
service is required as a minimum in order to initiate that the IPC runs down after a (buffered)
power failure. SDS can be configured in the MGR, but also directly via an integrated web
interface (required for systems without MGR).
3. The SITOP Gateway Service (GWS) - represented by symbol (
) - is responsible for
communication between SITOP UPS1600 with USB interface, SITOP DC UPS module with
USB interface, SITOP UPS500P with USB interface and between SITOP UPS500S with USB
interface on one side and the OPC UA interface on the other side, which is required for SDS
and MGR. The Gateway Service is installed on the IPC at which devices SITOP UPS1600,
SITOP DC UPS module, SITOP UPS500P or SITOP UPS500S are physically connected via a USB
port.
Together, these three services form the SITOP Manager software product.
Application
Using the SITOP Manager, you can execute the most important tasks:
• Commissioning and monitoring several SITOP PSU8600 SITOP, UPS1600, SITOP DC UPS
module, SITOP UPS500P and SITOP UPS500S
• Online engineering involving several SITOP PSU8600 SITOP, UPS1600, SITOP DC UPS
module, SITOP UPS500P and SITOP UPS500S
• Offline engineering involving several SITOP PSU8600 SITOP, UPS1600, SITOP DC UPS
module, SITOP UPS500P and SITOP UPS500S
• Controlled shutdown of buffered IPC systems (24 Volt)
• Backup and import of project configurations for archiving and replacement
• Secure data exchange and communication
To Next Page
Loading...
