Engineering and remote access
3.10 OPC UA server
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
169
BecauseChargingDeac-
Low charge status of the battery as a result of deactivated
charging function.
AlarmBatterySOHtest
CanceledBuffering
Capacity test canceled. Buffering was started.
CanceledByConfigura-
Capacity test canceled due to changed or invalid configura-
tion
AlarmBatterySOHtest
CanceledByUser
User canceled the capacity test.
CanceledInputVolt-
Capacity test canceled. Input voltage is too high
CanceledInsufficient-
The capacity test was canceled due to an insufficient system
load.
AlarmBatterySOHtest
CanceledNotFull
Capacity test canceled. Batteries are not fully charged.
AlarmBatterySOHtest
Running
Capacity test being performed.
AlarmBatterySOHtest
Running
Battery 'State of Health' tests (SoH) are in progress.
AlarmBufferMode
NotPossible
Buffer mode not possible - check settings, cabling, fuse, and
battery voltages
Device is in buffer mode.
AlarmChargeCurrent
ManualChanged
Max. permissible charging current was limited as a result of
the configuration parameters
AlarmCommunication
ToDeviceFailed
PROFINET connection available - SITOP UPS1600 is defective
AlarmDevice
Overtemperature
Output and battery charging is switched off to prevent dam-
age to the device.
AlarmDevice
ParameterCorrupt
SITOP UPS1600 parameters corrupt - try to update the soft-
ware.
AlarmDevice
TemperatureHigh
Device temperature higher than 100° C. Caution: The high-
est permitted temperature could be exceeded!
AlarmDevice
TemperatureLow
Device temperature lower than -10° C. Device could leave
the operating range.
SITOP UPS1600 off - buffer time exceeded or PC was shut
down
Previous software update was successful - SITOP UPS1600 is
operational again.
Input voltage exceeds 30 V. SITOP UPS1600 is not opera-
tional.
The configured buffer time may not be reached at this time
due to the low battery charge.
To Next Page
Loading...
