Siemens SITRANS FC330 - Page 122

Parameter list read only view
Lists of parameters in read only view are displayed as shown below.
4
2
1
3
① Parameter value selected
② Parameter name
③ Parameter item number
④ Help text describing the parameter function. The help text appears if no key is pressed for three
seconds.
Figure 7-9 List selection read only view
The read only view is shown if you do not have access to edit parameters. Press to escape
the view.
Multiselection view
It is possible to select/deselect multiple alarms to be enabled under menu item 3.2.7 "Enable
alarms".
1
2
3
① Parameter name
② Alarm list
③ Help text describing the parameter function. The help text appears if no key is pressed for three
seconds.
Use and to scroll through the alarms. Use to select/deselect the alarm.
The marked alarms will NOT be suppressed.
Note
Save settings
To activate the selections, press to save settings before leaving the view.
Operating
7.1 Local operation (HMI)
SITRANS FC330
122 Operating Instructions, 01/2019, A5E44030648-AB