Operating Manual - English Triax QUATTRO
- 70 - Copyright Silca 2011
1
The problem occurs after replacing the machine mother
board.
The machine memory has no MACHINE ID. Use the
WinTransfer/SRS program to do a CONNECTION TEST.
ERROR 10
Machine ID not set!
See operating manual.
An error has occurred when calculating the cuts or
searching by code. Make a note of the error and the
condition which caused it and advise After-Sales Service.
ERROR 43
INTERNAL ERROR
Error in searching data or in
cutting calculation.
See code:
An error has occurred in calculating the engraving path.
Make a note of the error and the condition which caused
it and advise After-Sales Service.
ERROR 13
Error in calculating
engraving process!
Code:
Error in loading data onto the machine with the USB-
PEN. Please repeat the operation to reload the data onto
the USB-PEN. If the error persists, make a note of it and
the condition which caused it and advise After-Sales
Service.
ERROR 16
Error during data updating
procedure via USB PEN.
Error code:
The message indicates that the machine has skipped
some steps during the job.
The user should check the key just cut and if necessary
repeat the entire cutting process for the last key cut.
ERROR 17
Loss of steps detected!
Repeat this job?
No=STOP Yes=ENTER
To Next Page
Loading...
