SimCom SIM7600 Series User Manual

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
220
“at+cgdcont” defined is ipv4v6 :
[+CGPADDR: <cid>,<PDP_addr_IPV4>,<PDP_addr_IPV6>]
+CGPADDR: <cid>,<PDP_addr_IPV4>,<PDP_addr_IPV6> [...]]]
OK
ERROR
+CME ERROR: <err>
Execution Command
Responses
AT+CGPADDR [+CGPADDR: <cid>,<PDP_addr>]
+CGPADDR: <cid>,<PDP_addr>[...]]]
OK
SIM card supports IPV4V6 type
and the PDP_type of the command
“at+cgdcont” defined is ipv4v6 :
[+CGPADDR: <cid>,<PDP_addr_IPV4>,<PDP_addr_IPV6>]
+CGPADDR: <cid>,<PDP_addr_IPV4>,<PDP_addr_IPV6> [...]]]
OK
ERROR
+CME ERROR: <err>
Defined values
<cid>
A numeric parameter which specifies a particular PDP context definition (see AT +CGDCONT
command). If no <cid> is specified, the addresses for all defined contexts are returned.
1…24,100…179
<PDP_addr>
A string that identifies the MT in the address space applicable to the PDP. The address may be static
or dynamic. For a static address, it will be the one set by the AT +CGDCONT command when the
context was defined. For a dynamic address it will be the one assigned during the last PDP context
activation that used the context definition referred to by <cid>. <PDP_addr> is omitted if none is
available.
<PDP_addr_IPV4>
A string parameter that identifies the MT in the address space applicable to the PDP.
<PDP_addr_IPV6>
A string parameter that identifies the MT in the address space applicable to the PDP
when the
sim_card supports ipv6. The pdp type must be set to “ipv6” or “ipv4v6” by the AT+CGDCONT
command.
Examples
AT+CGPADDR =?
+CGPADDR: (1)
OK
SIMCOM CONFIDENTIAL FILE

SimCom SIM7600 Series Specifications

General

Brand	SimCom
Model	SIM7600 Series
Category	Control Unit
Language	English