Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
+CGQMIN: "IPV4V6",(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
9.10 AT+CGEQMIN 3G quality of service profile (minimum acceptable)
Description
The test command returns values supported as a compound value.
The read command returns the current settings for each defined context for which a QOS was
explicitly specified.
The write command allow the TE to specify a Quallity of Service Profile for the context identified
by the context identification parameter <cid>
which is checked by the MT against the negotiated
profile returned in the Activate/Modify PDP Context Accept message.
A special form of the write command, AT+CGEQMIN=<cid>
causes the requested for context
number <cid> to become undefined.
SIM PIN References
YES 3GPP TS 27.007
Syntax
+CGEQMIN: <PDP_type>,(list of supported <Traffic class>s),(list
of supported <Maximum bitrate UL>
<Maximum bitrate DL>s),(list of supported
UL>s,(list of supported <Guaranteed bitrate DL>
supported <Deliv ery order>s),(list of supported
size>s),(list of supported <SDU error ratio>
<Residual bit error Ratio>s),(list of supported
erroneous SDUs>s),(list of Supported <Transfer delay>
supported <Traffic handling priority>s),(list of supported <Source
statistics descriptor>s),(list of supported <
flag>s)
OK
ERROR
Read Command Responses
AT+CGEQMIN? +CGEQMIN: [<cid>,<Traffic class>,<Maximum bitrate UL>,
<Maximum bitrate DL>,<Guaranteed bitrate UL>,<Guaranteed
bitrate DL>,<Delivery order>,<Maximum SDU size>,<SDU error
ratio>,<Residual bit error ratio>,<Delivery of erroneous SDUs>,
<Transfer Delay>,<Traffic handling priority>,<Source statistics
descriptor>,< Signaling indication flag>][<CR><LF>+CGEQMIN:
To Next Page
Loading...
Need help?
General
