SimCom SIM7600 Series User Manual

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
165
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data> (text mode enabled)
<ds> （not used in CDMA/EVDO mode）
0 – No SMS-STAT U S-REPORTs are routed to the TE.
1 – SMS-STAT U S -REPORTs are routed to the TE using unsolicited result code:
+CDS: <length><CR><LF><pdu> (PDU mode enabled); or
+CDS: <fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st> (text mode enabled)
2 – If SMS-STAT U S -REPORT is stored into ME/TA, indication of the memory location is
routed to the TE using unsolicited result code: +CDSI: <mem3>,<index>.
<bfr>
0 –
TA buffer of unsolicited result codes defined within this command is flushed to the TE
when <mode> 1 to 3 is entered (OK response shall be given before flushing the codes).
1 –
TA buffer of unsolicited result codes defined within this command is cleared when
<mode> 1 to 3 is entered.
Examples
AT+CNMI?
+CNMI: 0,0,0,0,0
OK
AT+CNMI=?
+CNMI: (0,1,2),(0,1,2,3),(0,2),(0,1,2),(0,1)
OK
AT+CNMI=2,1 (unsolicited result codes after received messages.)
OK
7.10 AT+CGSMS Select service for MO SMS messages
Description
The write command is used to specify the service or service preference that the MT will use to send
MO SMS messages.
The test command is used for requesting information on which services and service preferences can
be set by using the AT +C G SM S write command
The read command returns the currently selected service or service preference.
Note: This command not support in CDMA/EVDO mode
SIM PIN References
YES
3GPP TS 27.007
Syntax
Test Command Responses
AT+ CGSMS=?
+CGSMS: (list of supported <service>s)
OK
SIMCOM CONFIDENTIAL FILE

SimCom SIM7600 Series Specifications

General

Brand	SimCom
Model	SIM7600 Series
Category	Control Unit
Language	English