SimCom SIM7600 Series User Manual

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
52
4 – disable phone both transmit and receive RF circuits
5 – Factory Test Mode
6 – Reset
7 – Offline Mode
<rst>
0 – do not reset the ME before setting it to <fun> power level
1 – reset the ME before setting it to <fun> power level. This value only takes effect when
<fun> equals 1.
Examples
AT+CFUN?
+CFUN: 1
OK
AT+CFUN=0
OK
4.2 AT+CPIN Enter PIN
Description
This command is used to send the ME a password which is necessary before it can be operated
(SIM PIN, SIM PUK, PH-SIM PIN, etc.). If the PIN is to be entered twice,
the TA shall
automatically repeat the PIN. If no PIN request is pending, no action is taken towards MT and an
error message, +CME ERROR, is returned to TE.
If the PIN required is SIM PUK or SIM PUK2, the second pin is required. This second pin,
<newpin>, is used to replace the old pin in the SIM.
SIM PIN References
NO 3GPP TS 27.007
Syntax
Test Command Responses
AT+CPIN=?
OK
Read Command Responses
AT+CPIN?
+CPIN: <code>
OK
ERROR
+CME ERROR: <err>
Write Command Responses
AT+CPIN=<pin>[,<newpin>
]
OK
ERROR
SIMCOM CONFIDENTIAL FILE

SimCom SIM7600 Series Specifications

General

Brand	SimCom
Model	SIM7600 Series
Category	Control Unit
Language	English