Simplex 4100 Operator's Manual

4-1
This chapter describes using the panel’s action keys (ALM TEST, ON, OFF, etc.) to test and
control system points.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Alarm and Fault Test for Monitor Points 4-2
Isolating and De-isolating Non-Alarm points 4-3
Disabling and Enabling Points 4-4
Turning a Point ON or OFF 4-5
Chapter 4
Testing and Controlling Points
Introduction
In this Chapter
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes