Simplex 4100 Operator's Manual

12-1
It is a requirement of AS1851 - Part 8, The Standards Association of Australia Code for
Maintenance of Automatic Fire Alarm Systems, that tests be carried out to ensure the system
is fully functional.
The owner or tenant of the premises usually carries out the weekly test described. The
installation company, under a Service Agreement, typically carries out the monthly and annual
tests.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Weekly Tests 12-2
Monthly Tests 12-3
Annual Tests 12-4
Chapter 12
Maintenance Procedures
Introduction
In this Chapter
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes