5-1
Many of the operations that can be accomplished from the operator interface first require you
to select the point on which you want to perform the operation. Points can be selected in one
of three ways.
• Alarm, Fault, or Isolate List. Points that are reporting an alarm or fault condition can be
selected from the alarm or fault list. Refer to Chapters 2 and 3 for information on
selecting points from these lists.
• Using the Menu.
• Using the Entry keys.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Selecting Points from the Menu 5-2
Selecting Points with the Entry Keypad 5-3
Chapter 5
Selecting Points for Status or Control
Introduction
In this Chapter
To Next Page
Loading...
