EasyManuals Logo

Simplex 4100 Operator's Manual

Simplex 4100
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
1-8
The action keys allow you to quickly perform common control functions. There are four
action keys on the display/action keypad:
Disable/Enable
Off/FLT TEST - Turning a point OFF
On/ALM TEST - Turning a point ON
Auto - Return a point to Auto Control
The ENTRY keypad is located to the far right on the operator interface panel and is concealed
by the access door. There are fourteen keys on this keypad as shown below.
These keys are used to enter passcodes, identifiers, or numeric data for the system. Whenever
the system expects numeric data input, the user is notified with a prompt. Numeric data input
requires an <ENTER> key press to complete the keypad entry. Numeric keys also double as
"prefix" keys. When entering a point, a prefix key must be used to identify how the entry is
made. Pressing the zone key (key 1) indicates that the next numeric entry is a zone number.
Pressing the address key (key 0) indicates that an address identifier is entered.
The <CLR> key is used to cancel operations and escape from menus and return to the System
Normal screen.
There are two keys – FAULT ACK and ISOLATE ACK – contained in the area labeled
FAULT/ISOLATE keys. These keys are used to acknowledge an unacknowledged fault or
isolate condition. If no unacknowledged fault or isolate conditions exist, these keys select
either the Fault or Isolate list.
Door Down – Service Related Features, Continued
Action Keys
Entry Keypad
FAULT / ISOLATE
Keys
firealarmresources.com

Table of Contents

Other manuals for Simplex 4100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simplex 4100 and is the answer not in the manual?

Simplex 4100 Specifications

General IconGeneral
TypeFire Alarm Control Panel
ManufacturerSimplex
Model4100
Network CapabilityYes
AddressableYes
Power Supply120/240 VAC, 50/60 Hz
DisplayLCD
Annunciator SupportYes
Battery BackupYes
Releasing CapabilityYes
Max DevicesDepends on configuration
Max Notification Appliance Circuits (NAC)Varies with configuration
Max Releasing CircuitsVaries with configuration
Max Remote AnnunciatorsVaries with configuration
Communication PortsMultiple
Operating Temperature32°F to 120°F (0°C to 49°C)
Humidity RangeUp to 93% RH, non-condensing
NAC Outputs4 (expandable)
NetworkingYes

Related product manuals